Much appreciated on your patience, effort and testing! but when i tried using ventoy, thats where it fails. if i dont use ventoy, i configure my usb as such, i am able to boot into my xpe.iso. Thank you so much for your patience and guidance! i am able to boot into my xpe.iso as per your instructions above. If this way is good, so your XPE.iso has no problem, I will try install Ventoy on this usb later, please wait.Hi Learning41421, I hope this one you could read in here.Ībout the script error, my friend has followed your instruction, it runs without that error, it showed the notice downloading ADK, then until nearly end, the error pops up again like below : Yesterday I sent 2 messages to your inbox, have you got them? It is impossible for me to post my reply to you only. Like yesterday and today, I did reply to Kyhi first, it went well but when I replied to kracie17 with quote, it automatically combined to my previous post for Kyhi, it showed Updated. If this way is good, so your XPE.iso has no problem, I will try install Ventoy on this usb later, please wait.Ĭould you tell me how to post my reply to each member, for examply to Kyhi, I click on Quote from his message then the new reply combined with the previous post. Open your iso with 7z, copy all contents to USB: I don't know why you are not able to boot, so you could try this way first to see if your XPE.iso OK on UEFI.įrom Bootice you do like below, I use my other old usb to show you: let me know where else i have gone wrong.

followed the steps and yet still unsuccessful.

Thank you for your quick guidance! i have updated my ventoy to be MBR, non secure boot.

Vtoyefi